www.naxa.com Page 17
Battery Installation
The remote control is powered by two (2) AAA-type
batteries.
1. Pull down on the tab of the battery compartment
cover to release the latch and then lift the cover off.
2. Remove the batteries and replace it with two new
“AAA” batteries.
3. Replace the battery compartment cover.
⚠L
Batteries in the remote will last for ap-
proximately 1 year. Replace the batteries if
the remote control does not work. Always
dispose of batteries according to your local
municipal regulations.
⚠⚠
The batteries used in the remote control
may present a re or chemical burn if
mistreated. Do not recharge, disassemble,
incinerate, or heat the battery (~212°F).
Keep batteries away from children.
Remove the batteries from the remote to
prevent leakage if it will not be used for a
long time.
Always replace batteries at the same time.
Do not mix new and old batteries.
Always use the same type of battery. Do
not mix battery types (e.g., alkaline with
manganese, or rechargeable batteries with
non-rechargeable batteries).
Do not spill water on the remote control.
Do not use the remote control for other
equipment at the same time.
To Next Page
Loading...
