Naxa NTD-2255 - Remote Control Functions

Page 14 Naxa Electronics
Remote Control
POWER
Press to turn the TV on or to
place it in Standby mode.
MUTE Press to disable audio out-
put. Press again to restore
audio output.
Number
keypad
(1-9, 0)
Use the number keypad to
input a value when prompted
on a menu or option screen.
–/––
Use the subchannel selector
key with the numeric keypad
to tune to a channel substa-
tion (e.g., 5-1, 5-2, 5–3).
RETURN Press to return to the previ-
ous channel.
P.MODE Press to cycle through the
picture mode presets.
S.MODE Press to cycle through the
sound mode presets.
SOURCE Press to access the input
source menu, then use the
arrow keys to change the
input source.
VOL + Press to increase the volume
level.
VOL – Press to decrease the vol-
ume level.
PROG + Press to tune to a higher
channel.
PROG – Press to tune to a lower
channel.
Press to browse up in menu
and option screens.
Press to browse down in
menu and option screens.
Press to browse to the left in
menu and option screens.
Press to browse to the right in
menu and option screens.
ENTER Press to conrm a selection
in menu and option screens.
SETUP /
EXIT
Press to access (and exit) the
DVD system setup menu.
MENU Press to access (and exit) the
TV system setup menu.