Getting Started with MAXserver Access Servers
0038
94
The following table lists the six methods available for loading images.
Table 7 - Image Loading Methods
Method Loads softare from
¼
¼
C Flash card.
D TFTP.
X Xyplex MAXserver Manager or from another unit that has
a flash card and the proper load image.
M DEC MOP loader protocol.
B BOOTP host
R RARP.
‘Y’ - All software loading methods will be used. Proceed to the next section
to continue the configuration
‘N ‘ - You are selecting specific method(s). The configuration menu prompts:
Toggle (CARD,DTFTP,XMOP,MOP,BOOTP,RARP) image load methods
[C,D,X,M,B,R]:
NOTE: Host setup activity is required for MOP, BOOTP, and RARP
protocols.
1. Select specific protocol(s) by removing letters from or adding letters to
the brackets. To remove a letter, type the letter and press RETURN.
The prompt reappears; however, the letter you typed does not appear
within the brackets. To add a letter to those within the brackets, type
the letter and press RETURN. The prompt reappears and the letter you
typed is included within the brackets.
2. Press RETURN again, the unit prompts you to enable parameter loading
methods. Proceed to the next section to continue.
To Next Page
Loading...