7167 Owner’s Manual Chapter 6: Commands
November 2003
228
Set Cropping Area FS ( g pL pH fn n x1 y1 x2 y2 (when fn = 57)
The area to be cropped is the area of data that is to be retained. The remaining area of the scanned
area is returned as “white” data. The area to be cropped is defined by n.
• x1, y1 specifies the starting point to be cropped
• x2, y2 specifies the ending point to be cropped
• The scanning range is 102 mm (4.02) in the X direction and 230 mm (9.06) in the Y direction.
x2 > 102 specifies the maximum cropping range (= 102) in the X direction.
y2 > 230 specifies the maximum cropping range (= 230) in the Y direction.
• All values are specified in millimeters for the distance from the origin of the check.
(lower left corner of the check).
ASCII FS ( g pL pH fn n x1 y1 x2 y2
Hex 1C 28 67 pL pH fn n x1 y1 x2 y2
Decimal 28 40 103 pL pH fn n x1 y1 x2 y2
Range (pL + pH x 256) = 6 (pL = 6, pH = 0)
Fn = 57
1 < n < 10
x
1scan
< x1 < x
2scan
y
1scan
< y1 < y
2scan
x1 < x2 <
x
2scan
y1 < y2 <
y
2scan
Default No cropping area is set
Scan Area outside cropping areas are turned white and sent together when CropID
in corresponding commands are not 41H-4AH
Data in cropping
area retained
Cropping area 1
To Next Page
Loading...
