NDC BenchMike Pro - Page 116

6-8 BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Remote Setup
EQUATION TOO LONG
BAD EQUATION
BAD SEGMENT
DIVIDE BY ZERO
TOO MANY SEGMENTS
STRING TOO LONG
BAD FORMAT
INVALID SELECTION
NO GOOD MEASUREMENT
NO I/O CARD PRESENT
COMMAND FAILED
DUPLICATE DH+ NODE
UNIT MUST BE OFFLINE
DISABLED BY DIP SWITCHES
DATA LIST TOO LONG
FEATURE NOT ENABLED
BAD VALUE
Here is the format of a message from the BenchMike Pro to the host device, with a sample message, when the
message is not a response to a host request. This message is sent when the BenchMike Pro is configured to
transmit measurements as soon as they are available (i.e, .MEAS.POLLED:NO).