NDC BenchMike Pro - 8 Specifications; Operational Specifications; Performance Specifications; General Benchmike Pro Specifications (2025 and 2050)

CHAPTER
8
BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Specifications 8-1
8 Specifications
8.1 Operational Specifications
Dimensions (H x W x D)
253 x 641 x 194 mm (10 x 25.24 x 7.7 in.)
Power Requirements
100-240 V AC, 50-60 Hz, 90 VA
Weight
24 kg (53 lbs.)
Operating Temperature
7-36 °C (45-97 °F) at 80% relative humidity for tem-
peratures up to 31°C, decreasing linearly to 50%
relative humidity at 40°C.
Storage Temperature
-20 to 60 °C (-4 to 140 °F)
Environment
For use indoors in a non-condensing environment;
altitude up to 2000 m; no IP rating.
Installation category
II
Pollution degree
2
8.2 Performance Specifications
The following tables list performance specifications for the 2025 and 2050 BenchMike Pros, as well as separate
specifications for each.
8.2.1 General BenchMike Pro Specifications (2025 and 2050)
Mounting Holes
Two (2) at Pass Line location; M6 (all others)
Setup Parameters
Saved in non-volatile memory (NVM)
Calibration
Factory calibrated
Laser Source
Z-Mike 4025/4050: HeNe gas laser; 1 mW output
BenchMike 2025/2050: 635 nm 1 mW collimated diode
Display
480 x 800 liquid crystal display; 16000 colors
Programmable Display
Resolution
From X.1 to X.000001 in.
ScanRate
100 per second