2-2 BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Installation
2.1.6 Caution Symbol
This product should only be used or serviced by trained NDC Technologies personnel.
Failure to do so could result in physical injury, damage to the product, and/or voiding of
the warranty. If you have any questions or problems, please contact the NDC Technolo-
gies Customer Service Department.
2.2 Drawings
Use the following drawings to install the BenchMike Pro.
2.2.1 Model 2025
2.2.1.1 Outline Drawing
Note: Dimensions are in mm (inches)
Note: mount the universal mounting plate with the -10 in the lower left corner (as seen looking downward from the
operator’s position) of the BenchMike Pro’s measurement area.
To Next Page
Loading...
Need help?
General
