NDC BenchMike Pro - Page 125

BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Remote Setup 6-17
OFF. Examples:
CONF.SER.FORMAT.DECIMAL:ON
CONF.SER.FORMAT.DECIMAL:OFF
CONF.SER.FORMAT.DELAY
Request or specify the time delay in seconds for serial da-
ta. Examples:
CONF.SER.FORMAT.DELAY:5.0
CONF.SER.FORMAT.DELAY?
CONF.SER.FORMAT.HEADER
Request or specify the header used. Options are: NONE,
SOH, STX, and EXCLAM, where SOH=ASCII 001, STX=ASCII
002, and EXCLAM=ASCII 033 (!) Examples:
CONF.SER.FORMAT.HEADER:NONE
CONF.SER.FORMAT.HEADER?
CONF.SER.FORMAT.LABEL
Turn the label for serial data ON or OFF. Examples:
CONF.SER.FORMAT.LABEL:ON
CONF.SER.FORMAT.LABEL:OFF
CONF.SER.FORMAT.REQ
Request or specify the REQ for serial data. Options are:
CR, ENQ, and QUES. Examples:
CONF.SER.FORMAT.REQ:CR
CONF.SER.FORMAT.REQ?
CONF.SER.FORMAT.SEP
Request or specify the separator character for serial data.
Options are: NONE, SPACE, COMMA, SEMICOLON, CR, LF,
CR/LF, and TAB.
Examples:
CONF.SER.FORMAT.SEP:NONE
CONF.SER.FORMAT.SEP?
CONF.SER.FORMAT.SIGN
Turn the inclusion of a +/- sign in front of a number ON
or OFF. Examples:
CONF.SER.FORMAT.SIGN:ON
CONF.SER.FORMAT.SIGN:OFF
CONF.SER.FORMAT.TERM
Request or specify the termination character for serial da-
ta. Options are: NONE, CR, LF, CR/LF, and ETX. Examples:
CONF.SER.FORMAT.TERM:NONE
CONF.SER.FORMAT.TERM?.CONF.SER.PAR
CONF.SER.FORMAT.TIME
Turns the date/time stamp for serial data ON or OFF. Ex-
amples:
CONF.SER.FORMAT.TIME:ON
CONF.SER.FORMAT.TIME?
CONF.SER.PAR
Request or specify the parity of the selected serial port.
Odd, even, and no parity are available. Examples:
CONF.SER.PAR?
CONF.SER.PAR:E
CONF.SER.PAR:O
CONF.SER.PAR:N