User Guide
133
www.nec-computers.com
with a number (minimum is 1), starting from the smallest number. The ID is same
value than the Connected Port shown in Physical Drives Properties box in WebBIOS.
The Enclosure number and Slot number start from 1.
Caution
Note that the slot numbers shown in Physical Drives box of
WebBIOS are represented starting from 1, but those in Univer-
sal RAID Utility are represented starting from 0.
Priority Settings
WebBIOS displays and sets the Rebuild Priority and the Consistency Check Priority of
the RAID Controller using a percentage whereas the Universal RAID Utility uses three
levels (High/Middle/Low).
Table 28: Priority and Value Settings
Item WebBIOS Setting Value Universal RAID Utility Level
Rebuild Priority
Rebuild Rate (WebBIOS)
80 to 100 High
31 to 79 Middle
0 to 30 Low
Patrol Read Priority
Patrol Read Rate (WebBIOS)
80 to 100 High
31 to 79 Middle
0 to 30 Low
Consistency Check Priority
Consistency Check Rate (Web-
BIOS)
80 to 100 High
31 to 79 Middle
0 to 30 Low
Table 29: Settings Levels and Values
Item Setting level of
Universal RAID
Utility
Setting value
Rebuild Priority
Rebuild Rate (WebBIOS)
High 90
Middle 50
To Next Page
Loading...