User Guide
156
www.nec-computers.com
1. See the section “Preparing Your System for Upgrade” on page 137 to prepare.
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See “Drive Cover” on page 141 and
“Logic Cover” on page 143.
4. Remove the PCI riser module. See “Installing and Removing a PCI Board” on
page 166.
5. Remove the two screws securing the support arm.
6. Remove the support arm from the chassis.
Figure 107: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Press firmly on the support arm to remove the screws.
7. Remove the processor duct from the chassis.
Figure 108: Removing the Processor Duct
To Next Page
Loading...