User Guide
244
www.nec-computers.com
0611 IDE configuration changed Check IDE configuration.
0612 IDE configuration error - device disabled
0613 COM A configuration changed Check COM A configuration.
0614 COM A configuration error - device disabled
0615 COM B configuration changed Check COM B configuration.
0616 COM B configuration error - device disabled
0B22 Processors are installed out of order. Request the maintenance to replace the CPU.
0B28 Unsupported Processor detected on
Processor 1.
Make sure that the server supports the CPU. If you
are not sure, contact your service representative to
request the maintenance.
0B29 Unsupported Processor detected on
Processor 2.
0B30 FAN1 Alarm occurred. Contact your service representative to replace the
fan.
0B31 FAN2 Alarm occurred.
0B32 FAN3 Alarm occurred.
0B33 FAN4 Alarm occurred.
0B34 FAN5 Alarm occurred.
0B35 FAN6 Alarm occurred.
0B36 FAN7 Alarm occurred.
0B37 FAN8 Alarm occurred.
0B38 FAN9 Alarm occurred.
0B39 FAN10 Alarm occurred.
0B3A FAN11 Alarm occurred.
0B3B FAN12 Alarm occurred.
0B3C FAN13 Alarm occurred.
0B3D FAN14 Alarm occurred.
0B3E FAN15 Alarm occurred.
0B42 Resource conflict Contact your service representative.
0B43 Warning: IRQ not configured
0B45 System Configuration Data Write Error
0B50 Processor #1 with error taken off-line. The system is forcibly started because an error was
detected in the CPU. Contact your service
representative.
0B51 Processor #2 with error taken off-line.
0B5F Forced to use processor with error.
0B60 DIMM group #1 has been disabled Contact your service representative.
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
0B63 DIMM group #4 has been disabled
0B64 DIMM group #5 has been disabled
0B65 DIMM group #6 has been disabled
0B70 The error occurred during temperature
sensor reading.
Contact your service representative.
0B71 System Temperature out of the range. Contact your service representative to replace the
fan.
0B74 The error occurred during voltage sensor
reading.
Contact your service representative.
0B75 System voltage out of the range.
Table 31: POST Error Messages (Continued)
Error
code
Error message Recommended Action
To Next Page
Loading...