User Guide
246
www.nec-computers.com
8151 Password cleared by jumper. Start SETUP and provide the settings again.
8160 Mismatch Processor speed detected on
Processor 1.
Start SETUP and set a password again.
8161 Mismatch Processor speed detected on
Processor 2.
Contact your service representative.
None Expansion ROM not initialized – PCI Mass
Storage Controller in slot n (n: slot number)
Disable initialization of the optional device expansion
ROM by using the BIOS SETUP utility (see
“BIOS
Setup Utility” on page 64).
H/W Configuration of BMC is corrupted.
!! Update BMC F/W Configuration by config-
uration tool !!
!! Refer to BMC configuration manual !!
Use NEC ExpressBuilder to configure the optional
remote management card .
Table 31: POST Error Messages (Continued)
Error
code
Error message Recommended Action
To Next Page
Loading...