NEC Express5800 120Rj-2 - Page 71

User Guide
71
www.nec-computers.com
PCI Device, Onboard LAN Submenu
Peripheral Configuration Submenu
Table 10: PCI Device, Onboard LAN Submenu
Feature Choices or
Display Only
Description Your Setting
LAN Controller Disabled
Enabled
This option allows you to
enable or disable the onboard
LAN controller
LAN1 Option ROM
Scan
Disabled
Enabled
Initializes device expansion
ROM.
Only if Onboard LAN Controller
is enabled.
LAN2 Option ROM
Scan
Disabled
Enabled
Initializes device expansion
ROM.
Only if Onboard LAN Controller
is enabled.
Table 11: Peripheral Configuration Submenu
Feature Choices or
Display Only
Description Your Setting
Serial Port A Disabled
Enabled
Auto
Enables or disables the serial
port A
Base I/O address 3F8
2F8
3E8
2E8
Set the base I/O address for
serial port A
Interrupt IRQ3
IRQ4
Set the interrupt for serial port A
Serial port B Disabled
Enabled
Auto
Enables or disables the serial
port B
Base I/O address 3F8
2F8
3E8
2E8
Set the base I/O address for
serial port B
Interrupt IRQ3
IRQ4
Set the interrupt for serial port B
USB Controller Disabled
Enabled
Enables or disables the USB
controller.
USB 2.0 Controller Disabled
Enabled
Enables or disables the USB
2.0 controller.
Parallel ATA Disabled
Enabled
Enables or disables the Parallel
ATA.
Serial ATA Disabled
Enabled
Not supported in this system.
Leave the factory setting as is.
SATA Controller
Mode Option
Compatible
Enhanced
SATA AHCI Disabled
Enabled