5-38 ODU MOUNTING
NWD-107460-02E Installation
Change of Polarization of TX SPAN ATT
Note The TX ATT is set to V-polarization when shipped from the factory.
1 If you change to H polarization, loosen two screws, rotate the antenna connection
unit and put the TX ATT horizontally,
2 Check that aperture of the connection unit is rotated as shown below, then fix it
with the two screws that were loosened in step 1.
TX ATT
Antenna
connection unit
V Polarization
Guide pin
Cross-recessed
Head machine screw
M2.6 (2ea)
Plate-2
Plate-1
H Polarization
V Polarization
32/38 GHz Band TX SPAN ATT Polarization Change
Submission Prohibited
NEC Internal Use Only
To Next Page
Loading...
