NEC iPasolink 200 - N-P Connector Used for ODU if IN;OUT

6-20 CABLE TERMINATION
NWD-107460-02E Installation
Procedure 6-4 N-P Connector used for ODU IF IN/OUT
(L-angle: 300PNR-C-NC)
1 Remove of Jacket of cable
Remove 6.5 mm of Jacket only, exposing braided wire.
Note Do not damage the braided wire.
2 The braided wires processing-1
(1) Fold the braided wire around jacket.
(2) Remove 5.0 mm of insulator.
Tools
• knife, cutter, nipper, tweezers, file, comb,
measure, clearance gauge, etc.
• spanner, torque spanner; 16 mm,15 mm
Tools
•knife
• cutter
•measure, etc.
Outlines of parts
Applicable cable: 5D-FB-E]
[
Cable jacket
Aluminum tape
(Connector body) (Parts A)
A
(Parts B)
B
Center conductor
Insulator
Braided wire
Clamp nut
6.5 mm
Submission Prohibited
NEC Internal Use Only