6-10 CABLE TERMINATION
NWD-107460-02E Installation
(e) Set the torque spanner.
Tightening only of clamp nut by torque spanner.
Tightening the connection to the torque value of 9 to 11 N·m.
Notes
1 When inserting, do not put the chip which is braided wire inside the
central conductor and the connector body.
2 Do not turn connector body, turn clamp nut attachment.
Tools
• spanner (14 mm)
• torque spanner (14 mm)
• clearance gauge, measure
Submission Prohibited
NEC Internal Use Only
To Next Page
Loading...
