NEC SL1000 - Mounting the Expansion Interface Card; Mounting the 408 E-A1;008 E-A1;000 E-A1;1 PRIU-C1 Pcbs; Figure 2-63 Removing the Sub-Cover

Items List of Contents QTY
IP4WW-2BRIDB-C1 2BRIDB-C1 PCB 1
Nylon Spacers 2
2BRI Label 1
Metal Spacers 1
Screws (with circular washer) 2
IP4WW-1PRIU-C1 1PRIU-C1 PCB (with PKG Spacer) 1
Nylon Spacers 2
Metal Spacers 2
Screws (with circular washer) 2
3.3 Mounting the Expansion Interface Card
DO NOT POWER ON until all installation has been completed.
Fit the optional 2BRIDB-C1 daughter boards before installing the 000E-A1/008E-A1 PCBs. Set the
switches on the 2BRIDB-C1 board before mounting it onto the 000E-A1/008E-A1 PCB.
3.3.1 Mounting the 408E-A1/008E-A1/000E-A1/1PRIU-C1 PCBs
The procedure for mounting the expansion interface cards is as follows;
• Do Not Power on until all installation have been completed.
• If Expansion KSU(s) are installed, turn the power on/off in the order of
Expansion 3 KSU, Expansion 2 KSU, Expansion 1 KSU and then Main
KSU.
1. Turn off the system power and disconnect the AC cord from KSU.
2. Open and remove the Sub-cover.
Sub-Cover
Sub-Cover
Tab
Tab
Figure 2-63 Removing the Sub-cover
ISSUE 3.0
SL1000
Hardware Manual 2-43