NEC SL1000 - Figure 2-71 Plastic Knockouts on 008 E-A1;000 E-A1; Figure 2-72 Installing the 2 BRIDB-C1

1. Cut and remove specified Plastic Knockouts on the 008E-A1/000E-A1 PCB.
008E-A1
000E-A1
Plastic Knockout
Plastic Knockouts
Figure 2-71 Plastic Knockouts on 008E-A1/000E-A1
2. Insert two Nylon-spacers into the specified holes. Using supplied screw, fasten Metal Spacer to
2BRIDB-C1 PCB.
3. Mount the 2BRIDB-C1 PCB onto the 008E-A1/000E-A1 PCB using two Nylon-spacers and one
screw. (Refer to Figure 2-72 Installing the 2BRIDB-C1 on page 2-48)
4. Attach the 2BRI Label to the specified position on the 008E-A1/000E-A1 PCB.
008E-A1/000E-A1 PCB
Nylon-Spacers
J3
J1
Metal-Spacer
2BRI Label
2BRIDB-C1 PCB
Screw
Screw
Figure 2-72 Installing the 2BRIDB-C1
The 2BRIDB-C1 cannot be mounted on the 408M-A1/408E-A1/1PRIU-C1 PCB.
SL1000 ISSUE 3.0
2-48 Installation