NEC SL1000 - Mounting the 2 BRIDB PCB; Figure 2-69 Plastic Knockouts; Figure 2-70 Replacing the Main-Cover

8. Cut and remove the Plastic Knockouts as required for each Expansion interface card.
Main-Cover
Plastic
Knockouts
EXP.1st PCB
EXP.2nd PCB
EXP.3rd PCB
Figure 2-69 Plastic Knockouts
9. Replace the Main-cover and fasten two screws.
Two screws
Hooks
Main-Cover
Figure 2-70 Replacing the Main-cover
3.3.2 Mounting the 2BRIDB PCB
Set the switches on the 2BRIDB-C1 PCB before mounting onto the 008E-
A1/000E-A1 PCB, refer to the Switch Setting on page 2-53.
ISSUE 3.0 SL1000
Hardware Manual 2-47