6 BEEPS ON ARMING
Normally the keypad/s onboard SONALERT gives 3 beeps when the panel is armed.
Turning this option ON will give 6 keypad beeps when Arming.
PROGRAMMING SEQUENCE:
P69E 4E toggles the option ON and OFF
OFF: Keypad gives 3 beeps on Arming
ON: Keypad gives 6 beeps on Arming
P69E 4E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
OFF: Keypad gives 3 beeps on Arming.
NOTES
The keypad beeps on Arm/Disarm when
Arming/Disarming by keypad, keyswitch
or by Radio Key.
QUIET HOME SIREN
PROGRAMMING SEQUENCE:
P69E 3E toggles the option ON and OFF
OFF: Normal siren sound in Home Mode
ON: Quiet Siren sound in Home Mode
FLASH STROBE ON MEDICAL ALARM
This option enables the strobe output when a medical alarm is triggered. This is to
make the house visible to the ambulance . The strobe will reset after 72 hours or when
a valid code is entered.
PROGRAMMING SEQUENCE:
P69E 3E toggles the option ON and OFF
OFF: Strobe does not flash on medical alarm
ON: Strobe flashes on medical alarm
P69E 3E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
OFF: Normal siren sound in Home
Mode.
NOTES
This does not affect the RESET output.
P69E 1E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
OFF
RELATED OPTIONS
P64E 8E Enable medical alarm.
Option No. Description Default
P69E
1E Flash strobe on medical alert
OFF
2E [not used]
OFF
3E Quiet Home Siren
OFF
4E 6 beeps on Arming
OFF
5E Home arm by radio key ON/OFF
OFF
6E Disable Mains Fail Alarm
OFF
7E Exit BEEPS - Full Arm
OFF
8E Exit BEEPS - Home Mode
OFF
36
Ness D8x / D16x Control Panel – Installation Manual
PROGRAMMING