P120E 1E
RELATED OPTIONS
P60E 2E, 3E Keyswitch options.
P120E 2E
NOTE. This option enables Radio Key Home
Arming chirps regardless of the state of
P64E 4E (Radio Key siren chirps).
RELATED OPTIONS
P64E 6E Strobe Flash on Home Arming
by Radio.
P120E 3E
NOTE
This option enables Radio Key Home
Arming chirp s regardless of the state
of P64E 4E (Radio Key siren chirps).
RELATED OPTIONS
P69E 5E Radio key Home arm by ON/OFF
buttons.
P120E 4E
RELATED OPTIONS
P120E 1E Latched Keyswitch.
P60E 2E, 3E Keyswitch options.
P120E 5E
RELATED OPTIONS
P120E 1E Latched Keyswitch.
P60E 2E, 3E Keyswitch options.
P120E 6E
NOTES
can be identified by viewing MEMORY. Only
one of the same consecutive zone warnings
is saved, although the MEMORY display will
flash each time (unless disabled by P94E
option).
outputs mapped to Home and Day alarms,
as programmed by options P63E 1E–8E.
other Home and Day mode outputs, (as set
by options P63E 1E–8E).
PROGRAMMING SEQUENCE:
P120E [1E–6E] Turns options on or off.
LATCHED KEYSWITCH
This option enables the use of a latched, (2 position on/off), keyswitch. Keyswitch
operation must first be enabled using options P60E 2E, 3E, page 24.
NOTE: ENABLING LATCHED KEYSWITCH DISABLES ALL OTHER METHODS OF
ARMING AND DISARMING (KEYPAD, RADIO KEY, CARD).
OFF: No Latched Keyswitch. (Factory default). ON: Latched Keyswitch enabled.
SIREN CHIRP ON HOME ARMING BY RADIO
This option enables siren chirps when arming and disarming Home Mode with a Radio
Key.
OFF: No Home Arm chirps. (Factory default). ON: Home Arm chirps enabled.
RADIO AUX BUTTON ARMS HOME MODE
This option enables the AUX button on a Ness RK4 Radio Key to arm Home Mode.
Aux2 options. See page 60).
(This option is independent of P69E 5E, Home arming by radio key ON/OFF buttons).
OFF: No AUX button Home Arm. (Factory default). ON: AUX button Home Arm enabled.
KEYSWITCH DISARM ONLY
Converts the use of keyswitch operation using P60E 2E and 3E to only DISARM either
from Area or Home mode. Keyswitch operation must first be enabled using options
P60E 2E, 3E, page 24.
OFF: Keyswitch arms and disarms. (Factory default). ON: Keyswitch disarms only.
KEYSWITCH ARM ONLY
Converts the use of keyswitch operation using P60E 2E and 3E to only ARM either from
Area or Home mode.
Keyswitch operation must first be enabled using options P60E 2E, 3E, page 24 .
OFF: Keyswitch arms and disarms. (Factory default). ON: Keyswitch arms only.
SMART BEEPS
Smart Beeps are available in Brief Home or Brief Day mode to identify zones by keypad
beeps.
When a Home zone or Day zone is triggered, the zone number is slowly beeped out,
followed by 2 seconds of silence. This is repeated 3 times and can be stopped by another
beep (such as keypress).
If the zone has entry delay you will hear the Smart Beeps sequence once when the zone is
triggered and again at the end of entry delay. If Entry Beeps are disabled (P60E 1E), Smart
Beeps will only be heard at the end of entry delay.
Smart Beeps use the keypad/s onboard sonalert, so option P63E 3E and/or 7E must be on
to enable the sonalert output for Home alarms and Day alarms.
OFF: Smart Beeps disabled
. (Factory default). ON: Smart Beeps enabled.
PROGRAM MODE LEVEL
Installer mode or NessComms.
Option No. Description Default
P120E
1E
Latched keyswitch input
OFF
2E
Siren Chirp on Home Arming by Radio
OFF
3E
Radio Key AUX arms Home Monitor
OFF
4E
Keyswitch ARM only
OFF
5E
Keyswitch Disarm only
OFF
6E
Smart Beep
OFF
7E
Entry Delay Timer1 x10
OFF
8E
Area2 Disarm by Keyswitch Allowed
OFF
56
Ness D8x / D16x Control Panel – Installation Manual
PROGRAMMING