EasyManua.ls Logo

NETASQ U30 - The U1100 Appliance; Front Panel

NETASQ U30
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION GUIDE
4. PRESENTATION OF THE APPLIANCES
4.7 The U1100 appliance
The U1100 appliance has the following characteristics:
Throughput of 2,800 Mbits/s.
800,000 concurrent connections.
8 Gigabit interfaces.
20,000 new sessions per second.
4.7.1 Front panel
1. Power LED (yellow): when this LED lights up, this means that the firewall is running.
2. Status LED (green).
3. Online LED (green).
Point 1: the Power LED (yellow) indicates that the product has been plugged in but has been shut
down.
The product is running when the Power LED and the Status and Online LEDs (green) are visible.
Point 2: When the appliance is starting, shutting down or being updated, the Status LED will light
up.
WARNING
You are strongly advised against switching off the product when the Status LED is starting,
shutting down or being updated.
The Status LED will blink (quick blinking every 250 milliseconds) in the event of a major failure of
the product (hardware modification, faulty network interface, etc). In this case, do contact your
distributor.
Point 3: The Online LED will be the last to light up when the product is running. Traffic will pass
through the interfaces.
For an appliance configured in high availability, the Online LED will light up intermittently (for every
second it lights up, it will go off for 2 seconds). This means that the appliance is in passive mode.
1
2
3

Table of Contents

Other manuals for NETASQ U30

Related product manuals