NETASQ U30 - Table of Contents

INSTALLATION GUIDE
1 INTRODUCTION 5
2 USAGE PRECAUTIONS 6
3 UPON RECEIVING YOUR FIREWALL 10
3.1 Integrity of the product 10
3.1.1 Labels 10
3.1.2 Quality seal 11
3.1.3 Firewall seal 12
3.2 Contents of the packaging 12
3.2.1 The chassis 13
3.3 Warranty and dismantling the appliance 13
4 PRESENTATION OF THE APPLIANCES 14
4.1 Front panels of products in the U range 14
4.2 The U30 appliance 15
4.3 The U70 appliance 16
4.4 The U120 appliance 17
4.5 The U250 appliance 19
4.6 The U450 appliance 20
4.7 The U1100 appliance 22
4.7.1 Front panel 22
4.7.2 Rear panel 23
4.8 The U1500 appliance 23
1.1.1. Front panel 23
4.8.1 Rear panel 24
4.9 The U6000 appliance 25
4.9.1 Front panel 25
4.9.2 Rear panel 26
4.10 The NG1000-A appliance 27
4.10.1 Front panel 27
4.10.2 Rear panel 28
4.11 The NG5000-A appliance 29
4.11.1 Front panel 29
4.11.2 Rear panel 30
5 CONNECTIONS 31
5.1 Installation precautions 31
5.1.1 Location 31
5.2 Power plug 31
5.3 Connection for administering the appliance 32
5.4 Connecting to the network 32
5.4.1 U30 32
5.4.2 U70 32
5.4.3 U120 33
5.4.4 U250 33
5.4.5 U450 33
5.4.6 U1100 33
5.4.7 U1500 33
5.4.8 U6000 34
5.4.9 NG1000-A 34
5.4.10 NG5000-A 35
5.4.11 Using a straight cable 35
5.4.12 Using a crossover cable (cable provided
with the product) 35
5.4.13 Antispoofing mechanism 36
6 PHYSICAL INSTALLATION OF THE
APPLIANCE 42
6.1 Preparation before installation 42
6.1.1 Preparation of the network cables 42
6.1.2 Preparation of the racking cabinet or bay43
6.1.3 Preparation of internet access 43
6.2 Placing the appliance in a bay 43
6.2.1 Installing a U30 or U70 43
6.2.2 Installing a U120, U250 or U450 44
6.2.3 Installing a U1100, U1500 or U6000 45
6.2.4 Preconfiguring a firewall 45
7 INITIAL CONNECTION TO THE PRODUCT 46
7.1 Prerequisites 46
7.1.1 Minimum configuration for configuring a
NETASQ firewall 46
7.1.2 Preparation of internet access 46
7.2 Configuration 47
7.3 Registering and installing the product 48
APPENDIX A: UPDATING THE LICENSE 45
Retrieving the license 45
Installing the license 47
APPENDIX B: RESETTING THE FIREWALL 48
APPENDIX C: ADDING AN ADDITIONAL U6000
NETWORK CARD 49
General points 49
Steps to follow 50
Scenarios for adding PCI-X cards 55
APPENDIX D: ADDING AN NG1000-A AND
NG5000-A EXTENSION MODULE 59
General points 59
APPENDIX E: ADDING A HARD DISK AND
ACTIVATING A RAID 1 ON THE NG1000-A 61
General points 61
APPENDIX F: REBUILDING A RAID 1 ON AN
NG1000-A OR AN NG5000-A 63
General points 63
APPENDIX G: INSTALLING THE 3G MODEM 64
General points 64
Installation procedure 65
APPENDIX G: INSTALLING VIA THE CD-ROM 66