NETASQ U30 - Registering and Installing the Product

INSTALLATION GUIDE
7. INITIAL CONNECTION TO THE PRODUCT
The procedure for configuring your Windows workstation is as follows:
Go to the Control panel on your Windows workstation,
Select the “Network” menu,
Select TCP/IP from the list of network elements, then “Properties”,
Indicate the address information required for the network configuration of the workstation:
IP address: 10.0.0.250 or the IP address you have selected for your workstation,
Subnetwork mask: 255.0.0.0,
Default gateway: indicate the current address of your firewall (10.0.0.254 by default).
Or configure your workstation so that it accepts a dynamic IP address from the appliance (DHCP
server):
Open the Network connections window
Windows 2000
Start > Control panel > Network and dial-up connections
Windows XP
Start > Control panel > Network and Internet connections
Right-click against “Connect to the local network” and select “Properties”.
Select “Internet Protocol (TCP/IP)” from the list, then “Properties”.
Select the option Obtain an IP address automatically and click on OK.
To confirm changes, click on OK again.
7.3 Registering and installing the product
Launch your preferred web browser and enter the address https://10.0.0.254/config/index.html.
This installation help web server will show you through the different steps in the configuration. you
may also use the Quickstart CD-ROM (Appendix G: Installing via the CD-ROM).
Next, you will be able to:
Configure the network to define the network architecture in which your product will be located.
Register your product in order to obtain updates
Perform the first updates
Obtain the license. For more information on this subject, please refer to Appendix A: Updating
the license.
Install the administration tools in order to obtain the Manager, Monitor and Reporter software
suite.