NetComm Wireless NF18ACV User Manual

VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
17 of 93
UG01040 v 1.04 December 2018
© NetComm Wireless 2018
ADSL
ADSL (Asymmetric Digital Subscriber Line ) technology supports
five CONNECTION TYPES:
PPPoE – The Point-to-Point Protocol over Ethernet.
PPPoA - Point-to-Point Protocol over ATM. It is available
only for ADSL
Dynamic IP – IP addresses are assigned by the ISP.
Static IP – Users define IP addresses for each device.
Bridge – The device relies on the configuration of
another gateway on the connection.
PPPoE
The Point-to-Point Protocol over Ethernet networking protocol
encapsulates PPP frames inside Ethernet frames and uses a
point to point connection between two Ethernet ports.
Your ISP will advise you of your default PPPoE authentication
Username and Password. Normally you will be given the
opportunity to change these to be more secure.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
are commonly 8 and 35 respectively.
PPPoA
Point-to-Point Protocol over ATM (Asynchronous Transfer
Mode) employs very small, fixed-length packets, in contrast to
PPPoE, which uses relatively large, variable-length packets.
PPPoA can be slightly faster than PPPoE.
Your ISP will advise you of your default Username and
Password. Normally you will be given the opportunity to
change these to be more secure.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
are commonly 8 and 35 respectively.
Dynamic IP
When the computer/router connects to the internet your ISP will
dynamically assign any available IP to it. Therefore the IP
address will change each time a new connection is established.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
are commonly 8 and 35 respectively.
Static IP
You must define, or purchase, a set IP address for each device
on the network.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
are commonly 8 and 35 respectively.
Contact your ISP for the WAN and DNS servers details.
Bridge
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
are commonly 8 and 35 respectively.

NetComm Wireless NF18ACV Specifications

General

Brand	NetComm Wireless
Model	NF18ACV
Category	Gateway
Language	English