VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
The Simple Network Management Protocol (SNMP) allows a network administrator to monitor
a network by retrieving settings on remote network devices.
To do this, the administrator typically runs an SNMP management station program such as
MIB browser on a local host to obtain information from the SNMP agent, in this case the
NF18ACV (if SNMP is enabled).
An SNMP ‘community’ performs the function of authenticating SNMP traffic.
A ‘community name’ acts as a password that is typically shared among SNMP agents and managers.
Select Enable to start this service.
Enter a read type or accept the default: public
Enter a community type or accept the default: private
Enter a recognisable system name or accept the default:
NF18ACV
Enter a system location or accept the default: unknown
Enter a system location or accept the default: unknown
Enter the IP address of the trap manager.
Click to save your settings and start the SNMP service.
To Next Page
Loading...
Need help?
General
