NetComm Wireless NF18ACV User Manual

VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
51 of 93
UG01040 v 1.04 December 2018
© NetComm Wireless 2018
Routing – NAT
The Routing – NAT page contains three sections Port Forwarding, DMZ Host and ALG.
Port Forwarding
Port forwarding allows you to direct incoming traffic from the WAN side to the Internal network host with a private IP address on the LAN side.
The table on the Port Forwarding page contains details of each Port Forwarding rule currently defined. You can define up to 32 rules
I T E M
D E F I N I T I O N
External Port Start
The starting external port number (when custom server is selected). When
a service is connected this field will be completed automatically.
External Port End
The ending external port number (when custom server is selected). When
a service is connected this field will be completed automatically.
Protocol
Options include: TCP, UDP or TCP/UDP
Internal Port Start
The starting internal port number (when custom server is selected). When a
service is connected this field will be completed automatically.
Internal Port End
The ending internal port number (when custom server is selected). When a
service is connected this field will be completed automatically.
I T E M
D E F I N I T I O N
Server IP Address
The IP address of the local server.
WAN Interface
Describes the type of target interface: ETH, WAN, VDSL, custom, etc.
WAN Loopback
Indicates current WAN Loopback status: Enabled or Disabled
Action buttons
Toggle between: Enable and Disable
Delete button
Click the Delete button to permanently remove a Port Forwarding rule.
Add button
Click Add to open the Add Virtual Servers page.
Click the Add button to create new Port Forwarding rules, see next page.

NetComm Wireless NF18ACV Specifications

General

Brand	NetComm Wireless
Model	NF18ACV
Category	Gateway
Language	English