VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
Configure a System Log
To configure the system log, click the
Configure System Log button.
When the desired values are selected
click Apply/Save to configure the
system log options.
When enabled the system will begin to log all the selected events.
Log Level
Emergency
Alert
Critical
Error
Warning
Notices
Informational
Debugging
The Log Level drop down list is arranged from most critical at the top
(Emergency), the lowest level event at the bottom (Debugging).
Select a Log Level and all events above or equal to the selected level
will be logged to a log file.
For example:
If you select Error as your Log Level, all Emergencies, Alerts,
Critical events and Error messages will be included in the log file.
Warnings, Notices, Informationals and Debugging messages will
not be logged.
Select a Display Level and , all logged events above or equal to the
selected level will be displayed on the System Logs page.
The range displayed is set using the same settings as described for
the Log Level settings, see previous item.
To view the System Logs page, click the View System Log button on
the Logs page:
The default setting, Local, saves the log only to the local memory on
the NF18ACV.
The Remote mode allows you to save the log on a remote server.
If the selected mode is Remote you must specify the IP address and
UDP port of the remote syslog server to which the log will be sent.
If Both is selected you must specify the IP address and UDP port of
the remote syslog server and events will be recorded in the local
memory as well as the remote server.
Specify the IP address of the remote syslog server. (Remote and both only.)
Specify the UDP port of the remote syslog server. (Remote and both only.)
To Next Page
Loading...
Need help?
General
