NetComm Wireless NF18ACV User Manual

VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
62 of 93
UG01040 v 1.04 December 2018
© NetComm Wireless 2018
LAN
Local Area Network – IPv4
Select IPv4 to configure this service.
I T E M
D E F I N I T I O N
IP Address
Enter the Local IP Address to use for the NF18ACV.
Subnet Mask
Enter the subnet mask to define the subnet of the Local Network.
DHCP
Select On to enable the DHCP server.
DHCP Start Range
Enter the start IP address for the DHCP IP Address pool.
DHCP End Range
Enter the end IP address for the DHCP IP Address pool.
Primary DNS Server
Enter the IP address of the primary DNS server.
Secondary DNS Server
Enter the IP address of the secondary DNS server.
DHCP Lease Time (Hour)
Assigned IP addresses will be dropped after this time period and the address
may be assigned to a different device on the network.
Default is 24 hours.
Enable IGMP Snooping
Enable IGMP (Internet Group Management Protocol) Snooping and select the
IGMP Snooping mode to use.
Standard Mode – Allows all multicast traffic to LAN clients.
Blocking Mode – Only allows multicast subscribed clients to receive multicast
packets.
Enable IGMP LAN to LAN
Multicast
Select Enable to start the service.
Select Disable to suspend the service.
Enable LAN side firewall
Enable the LAN side firewall to restrict traffic between LAN host-LAN hosts and
WiFi Clients.
Enable DHCP Server Relay
Disabled DHCP server, and relay all request to external server specified by the IP
address.

NetComm Wireless NF18ACV Specifications

General

Model	NF18ACV
Category	Gateway
WiFi Standard	802.11ac
Ethernet Ports	4 x Gigabit Ethernet
USB Ports	1 x USB 2.0
VoIP	2 x FXS Ports
WiFi Bands	Dual Band (2.4GHz & 5GHz)
WAN Port	1 x Gigabit Ethernet
Security	WPA/WPA2
DSL	VDSL2 / ADSL2+ / ADSL2 / ADSL