VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
RIP Configuration
The Routing Information Protocol (RIP) allows routers to exchange network topology
information.
This information allows the automatic creation and updating of routing tables.
The network interface that the RIP settings apply to.
1 – Use RIPv1 to support classful routing.
2 – Use RIPv2 to support subnet information gathering and
Classless Inter-Domain Routing.
Both – RIP will use both RIPv1 & RIPv2, and will multicast and
broadcast to all adjacent routers.
Passive – RIP will only respond to “Request Message” queries
on the RIP enabled interface.
Active – RIP will broadcast and respond to “Request Message”
queries on the RIP enabled interface.
Select Enable to activate the RIP routing service on the selected
Interface.
Click the Apply/Save button to save the changes and to initiate
the change.
Attention – RIP cannot be selected for a WAN interface which is NAT enabled, such as PPPoE.
Go to Basic Setup and select Ethernet WAN, click Next and then select IP over Ethernet (IPoE). The RIP option will now be available.
To Next Page
Loading...
Need help?
General
