NetComm Wireless NF18ACV

VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
81 of 93
UG01040 v 1.04 December 2018
© NetComm Wireless 2018
Internet Time
Select Advanced > System > Internet Time to show the Current Router Time.
The tools on this page allow you to use the Network Time Protocol (NTP) to configure specific time servers to synchronise time, set local time zones, etc. for the modem.
The time servers are correct to within a few milliseconds of Coordinated Universal Time (UTC), also known as Greenwich Mean Time (GMT).
I T E M
D E F I N I TI O N
Current Router Time
The current router time as per the settings in this page.
Automatically Synchronize
The router will periodically poll the designated NTP servers and confirm the correct
time.
First NTP Server
Enter the address of your primary Network Time Protocol (NTP) server.
Second NTP Server
Enter the address of your secondary Network Time Protocol (NTP) server (optional, but
recommended).
Time Zone Offset
Select your preferred time zone.
Normally this will be the location of the device.
Enable Daylight Savings Time
Coordinated Universal Time or Universal Time Coordinated (UTC) is not adjusted for
daylight saving time.
To display the Current Router Time in the actual local time where Daylight Savings
Time in in effect, select Enable Daylight Savings Time.
Apply/Save button
Click to apply any changes.