Router Internet Setup
24
N150 Wireless ADSL2+ Modem Router DGN1000
Setup Wizard
If you do not use the NETGEAR Genie, you have to log in to the modem router to set the
country, language, and Internet connection.
Note: If you performed the NETGEAR Genie setup, the country, language,
Internet, and wireless network settings are already configured.
To run the Setup Wizard
1. Select Setup Wi
zard from the top of the router menus to display the following screen:
2. Select your country and language:
• Country. It is import
ant to specify the location where the wireless modem router
operates so that the Internet connection works correctly. Defaults to UK.
• Language. Defaults to English. You can select anot
her language if you prefer.
3. Select either Ye
s or No, I want to configure the Router myself. If you select No, proceed
to Manual Setup (Basic Settings) on pa
ge 25.
4. If you selected Ye
s, click Next.
With automatic Internet detection, the Setup Wi
zard searches your Internet connection
for servers and protocols to determine your ISP configuration.
Note: The Setup Wizard cannot detect a Point-to-Point Tunneling Protocol
(PPTP) connection. If your ISP uses PPTP, you have to set your
Internet connection through the screen described in
Manual Setup
(Basic Settings) described on 25.
To Next Page
Loading...
Need help?
General
