Wireless Settings
38
N150 Wireless ADSL2+ Modem Router DGN1000
View or Change Wireless Settings
Your preset router comes set up with a unique wireless network name (SSID) and network
password. This information is printed on the label for your router. You can view or change
these settings in the Wireless Settings screen.
To change the wireless settings:
1. Select Setup > Wireless
Settings to display the following screen.
2. Make any changes that are needed and click Apply when done to save your settings.
Note: The screen sections, settings, and procedures are explained in the
following sections.
3. After you finish adjusting settings and click Apply, configure and test your computers for
wireless connectivity:
a. Program the wireless ad
apter of your computers to have the same SSID and channel
that you specified in the router.
b. Check that the adapters have a wireless
link and can obtain an IP address by DHCP
from the wireless modem router.
Wireless Network Settings
Name (SSID). The SSID is also known as the wireless network name. Enter a 32-character
(maximum) name in this field. This field is case-sensitive. The default SSID is randomly
generated, and NETGEAR strongly recommends that you not change this.
To Next Page
Loading...
Need help?
General
