Troubleshooting
86
N150 Wireless ADSL2+ Modem Router DGN1000
Router Not On
When you turn the power on, the power, LAN, and DSL LEDs should light as described here.
If they do not, refer to the sections that follow for help.
To check the LEDs:
1. When power is first applied, the Power LED lights.
2. After approximately 10 seconds, the LAN and DSL LEDs light as follows:
a. The LAN port LEDs light for any local ports that are connected.
b. The DSL link LED lights to indicate tha
t there is a link to the connected device.
c. If a LAN port is connected to a 10
0 Mbps device, verify that the LAN port’s LED is
green. Note that if the LAN port is 10 Mbps, the LED is amber.
Power
LAN Ports
DSL
Internet
Wireless
WPS
Figure 17. Front panel LED Icons
Power LED Is Off
If the Power and other LEDs are off when your router is turned on:
• Check that the
power cord is correctly connected to your router and the power supply
adapter is correctly connected to a functioning power outlet.
To Next Page
Loading...
Need help?
General
