128 | Chapter 4: Configuring Quality of Service
FS728TP Smart Switch Software Administration Manual
To map DSCP values to queues:
1. For each DSCP value, select a hardware queue to associate with the value.
The traffic class is the hardware queue for a port. Higher traffic class values indicate a
higher queue position. Before traffic in a lower queue is sent, it must wait for traffic in
higher queues to be sent. Valid range is 0–7.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3. If you make changes to the page, click Apply to apply the changes to the system.
To Next Page
Loading...
Need help?
General