54 | Chapter 2: Configuring System Information
FS728TP Smart Switch Software Administration Manual
To configure SNMP communities:
1. To add a new SNMP community, enter community information in the available fields
described below, and then click Add.
• Management Station IP. Specify the IP address of the management
station.Together, the Management Station IP and the Management Station IP Mask
denote a range of IP addresses from which SNMP clients may use that community to
access this device. If either (Management Station IP or Management Station IP Mask)
value is 0.0.0.0, access is allowed from any IP address. Otherwise, every client’s
address is ANDed with the mask, as is the Management Station IP Address; and, if
the values are equal, access is allowed. For example, if the Management Station IP
and Management Station IP Mask parameters are 192.168.1.0/255.255.255.0, then
any client whose address is 192.168.1.0 through 192.168.1.255 (inclusive) will be
allowed access. To allow access from only one station, use a Management Station IP
Mask value of 255.255.255.255, and use that machine’s IP address for Client
Address.
• Management Station IP Mask. Specify the subnet mask to associate with the
management station IP address.
• Community String. Specify a community name. A valid entry is a case-sensitive
string of up to 16 characters.
• Access Mode. Specify the access level for this community by selecting Read/Write or
Read Only from the menu.
• Status. Specify the status of this community by selecting Enable or Disable from the
pull down menu. If you select Enable, the Community Name must be unique among
all valid Community Names or the set request will be rejected. If you select Disable,
the Community Name will become invalid.
2. To modify an existing community, select the check box next to the community, change the
desired fields, and then click Apply. Configuration changes take effect immediately.
3. To delete a community, select the check box next to the community and click Delete.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Trap Configuration
This page displays an entry for every active Trap Receiver. To access this page, click
System SNMP SNMP V1/V2 Trap Configuration.
To Next Page
Loading...
Need help?
General