Chapter 7: Maintenance | 227
FS728TP Smart Switch Software Administration Manual
• If successful, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x,
Rx
= x Min/Max/Avg RTT = x/x/x msec.”
• If a reply to the ping is not received, you will see “Reply From IP/Host: Destination
Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.
Traceroute
Use the Traceroute utility to discover the paths that a packet takes to a remote destination.
To display this page, click Maintenance Troubleshooting Traceroute.
To configure the Traceroute settings and send probe packets to discover the route to a host
on the network:
1. In the Hostname/IP Address field, specify the IP address or the hostname of the
station you want the switch to ping. The initial value is blank. This information is not
retained across a power cycle.
2. Optionally, configure the following settings:
• Probes Per Hop. Specify the number of times each hop should be probed. The valid
range is 1–10.
• MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid
range is 1–255.
• InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range
is 0– 255.
• MaxFail. Specify the maximum number of failures allowed in the session. The valid
range is 0–255.
• Interval. Specify the time between probes in seconds. The valid range is 1–60.
To Next Page
Loading...
Need help?
General