Chapter 4: Configuring Quality of Service | 137
FS728TP Smart Switch Software Administration Manual
• Color Conform Mode. The match-criteria of the color Conform class.
• Committed Rate. The committed rate is specified in kilobits-per-second (Kbps) and is
an integer from 1–4294967295.
• Committed Burst Size. The committed burst size is specified in kilobytes (KB) and is
an integer from 1–128.
• Conform Action. Determines what happens to packets that are considered
conforming (below the police rate). Select one of the following actions:
• Send. (default) These packets are presented unmodified by DiffServ to the
system forwarding element.
• Drop. These packets are immediately dropped.
• Violate Action. Determines what happens to packets that are considered
non-conforming (above the police rate). Select one of the following actions:
• Send. (default) These packets are presented unmodified by DiffServ to the
system forwarding element.
• Drop. (default) These packets are immediately dropped.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch. Configuration changes take effect immediately.
7. Click Refresh to refresh the page with the most current data from the switch.
Service Configuration
Use the Service Configuration page to activate a policy on an interface.
To display the page, click QoS DiffServ Advanced Service Configuration.