EasyManuals Logo

NETGEAR FS728TPv2 User Manual

NETGEAR FS728TPv2
261 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
Chapter 3: Configuring Switching Information | 81
FS728TP Smart Switch Software Administration Manual
LACP Port Configuration
To display the LACP Port Configuration page, click Switching LAG Advanced LACP
Port Configuration.
To configure LACP port priority settings:
1. Select the check box next to the port to configure. You can select multiple ports to apply
the same setting to all selected ports.
Note: You cannot select ports that are not participating in a LAG
2. Configure the LACP Priority value for the selected port. The field range is 0–255. The
default value is 128.
3. Configure the administrative LACP Timeout value. The default value is Long.
Long. Specifies a long timeout value.
Short. Specifies a short timeout value.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.

Table of Contents

Other manuals for NETGEAR FS728TPv2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR FS728TPv2 and is the answer not in the manual?

NETGEAR FS728TPv2 Specifications

General IconGeneral
BrandNETGEAR
ModelFS728TPv2
CategorySwitch
LanguageEnglish

Related product manuals