50 | Chapter 2: Configuring System Information
FS728TP Smart Switch Software Administration Manual
• Status. View the operational status of the port PD detection.
• Disabled. Indicates no power is being delivered.
• Delivering Power. Indicates power is being drawn by a connected device.
• Fault. Indicates a problem with the port.
• Test. Indicates the port is in test mode.
• Other Fault. Indicates the port is idle due to an error condition.
• Searching. Indicates the port is not in one of the above states.
3. Click Apply to apply the new settings to the system.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. Click Refresh to update the screen with the current information.
Timer Global Configuration
Use the Timer Global Configuration page to create or remove timers and to control the
administrative status of the feature. Timers control when power can and cannot be delivered
to the port. Use the following general steps to add a timer to a port:
1. Create the timer on the Timer Global Configuration page.
2. Configure the timer settings on the Timer Schedule Configuration page.
3. Assign the timer to the port on the PoE Port Configuration page.
Note: The Timer Schedule feature must be enabled for the settings to be
applied to the ports.
To display the Timer Global Configuration page, click System > PoE > Advanced > Timer
Global Configuration.
To Next Page
Loading...
Need help?
General