14 | Chapter 1: Getting Started
FS728TP Smart Switch Software Administration Manual
6. Make a note of the displayed IP address assigned by the DHCP server. You will need this
value to access the switch directly from a Web browser (without using the Smart Control
Center).
7. Select your switch by clicking the line that displays the switch, then click the
Web
Browser Access button. The Smart Control Center displays a login window similar to
the following figure.
Use your Web browser to manage your switch. The default password is password. Then
use this page to proceed to management of the switch covered in
Using the Web
Interface on page 25.
To Next Page
Loading...
Need help?
General