204 | Chapter 6: Monitoring the System
FS728TP Smart Switch Software Administration Manual
To configure the Memory Log settings:
1. Use the radio buttons in the Admin Status field to determine whether to log messages.
• Enable: Enables system logging.
• Disable: Prevents the system from logging messages.
2. From the Behavior menu, specify the behavior of the log when it is full.
• Wrap: When the buffer is full, the oldest log messages are deleted as the system logs
new messages.
• Stop on Full: When the buffer is full, the system stops logging new messages and
preserves all existing log messages.
3. If you change the buffered log settings, click Apply to apply the changes to the system and
the changes will be saved.
The Memory Log table also appears on the Memory Log page.
The rest of the page displays the Memory Log messages. The format of the log message is
the same for messages that are displayed for the message log, persistent log, or console log.
Messages logged to a collector or relay via syslog have the same format as well.
Field Description
Total Number of Messages Displays the number of messages the system has logged in memory.
Only the 64 most recent entries are displayed on the page.
To Next Page
Loading...
Need help?
General