Chapter 6: Monitoring the System | 209
FS728TP Smart Switch Software Administration Manual
The following table describes the Trap Log information displayed on the screen.
The page also displays information about the traps that were sent.
Click Clear to clear all the counters. This resets all statistics for the trap logs to the default
values.
Field Description
Number of Traps Since
Last Reset
The number of traps that have occurred since the switch last reboot.
Trap Log Capacity The maximum number of traps stored in the log. If the number of traps exceeds the
capacity, the entries will overwrite the oldest entries.
Number of Traps Since
Log Last Viewed
The number of traps that have occurred since the traps were last displayed.
Displaying the traps by any method (such as terminal interface display, Web
display, or upload file from switch) will cause this counter to be cleared to 0.
Field Description
Log The sequence number of this trap.
System Up Time The time at which this trap occurred, expressed in days, hours, minutes, and
seconds since the last reboot of the switch.
Trap Information identifying the trap.
To Next Page
Loading...
