Chapter 2: Configuring System Information | 41
FS728TP Smart Switch Software Administration Manual
Auto-DoS Configuration
The Auto-DoS Configuration page lets you automatically enable all the DoS features
available on the switch, except for the L4 Port attack. See the previous section for information
about the types of DoS attacks the switch can monitor and block.
To access the Auto-DoS Configuration page, click System Management Denial of
Service > Auto-DoS Configuration.
To configure the Auto-DoS feature:
1. Select a radio button to enable or disable Auto-DoS:
• Disable. Auto-DoS is disabled (default).
• Enable. Auto-DoS is enabled.
2. Click Apply to send the updated configuration to the switch. Configuration changes occur
immediately.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
DoS Configuration
The DoS Configuration page lets you to select which types of DoS attacks for the switch to
monitor and block.
To access the DoS Configuration page, click System Management Denial of Service >
DoS Configuration.
To Next Page
Loading...
Need help?
General