ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
2-2 Connecting the FVS318G to the Internet
1.1 November, 2009
6. Configure the WAN options (optional). Optionally, you can enable each WAN port to
respond to a ping, and you can change the factory default MTU size and port speed. However,
these are advanced features and changing them is not usually required. See “Configuring the
Advanced WAN Options (Optional)” on page 2-15.
Each of these tasks is detailed separately in this chapter. The configuration of firewall and VPN
features is described in later chapters.
Logging into the VPN Firewall Router Router
To connect to the VPN firewall, your computer needs to be configured to obtain an IP address
automatically from the VPN firewall by DHCP. For instructions on how to configure your
computer for DHCP, refer to the link in Appendix B, “Related Documents.
To connect and log in to the VPN firewall follow these steps:
1. Start any of the qualified browsers, as detailed in “Qualified Web Browsers” on page 1-8.
2. Enter http://192.168.1.1 in the address field. The Manager login features appear in the
browser.
3. In the User field, type admin
4. In the Password field, type password
Note that both entries are in lower case letters.
Figure 2-1
To Next Page
Loading...
Need help?
General
