NETGEAR FVS318G - ProSafe Gigabit VPN Firewall Data Sheet Router User Manual

ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
4-10 Firewall Protection and Content Filtering
1.1 November, 2009
1. Click Add under the Outbound Services Table. The Add LAN WAN Outbound Service
screen is displayed..
2. Configure the parameters based on the descriptions in Table 4-1 on page 4-3.
3. Click Apply to save your changes and reset the fields on this screen. The new rule will be
listed on the Outbound Services table.
Creating a LAN WAN Inbound Services Rule
This Inbound Services Rules table lists all existing rules for inbound traffic. If you have not
defined any rules, no rules will be listed. By default, all inbound traffic is blocked. Remember that
allowing inbound services opens holes in your firewall. Only enable those ports that are necessary
for your network.
To create a new inbound service rule in the LAN WAN Rules tab:
1. Click Add under the Inbound Services Table. The Add LAN WAN Inbound Service screen
is displayed.
Figure 4-2

NETGEAR FVS318G - ProSafe Gigabit VPN Firewall Data Sheet Router Specifications

General

Model	FVS318G
Category	Network Router
VPN Tunnels	25
VPN Throughput	25 Mbps
VPN Protocols	IPSec, PPTP, L2TP
Humidity	90% maximum relative humidity, non-condensing
WAN Ports	1
LAN Ports	8
Weight	1.4 kg (3.1 lb)
Firewall Security	SPI, DoS
Flash Memory	8 MB
Operating Temperature	0° to 40°C
Storage Temperature	-20° to 70°C