ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
Virtual Private Networking Using IPsec 5-5
1.1 November, 2009
The tunnel will automatically establish when both the local and target gateway policies are
appropriately configured and enabled,
Creating a Client to Gateway VPN Tunnel
Follow these steps to configure the a VPN client tunnel:
• Configure the client policies on the gateway.
• Configure the VPN client to connect to the gateway.
Use the VPN Wizard Configure the Gateway for a Client Tunnel
1. From the main menu, go to VPN > VPN Wizard. The VPN Wizard displays.
Note: When using FQDN, if the dynamic DNS service is slow to update their servers
when your DHCP WAN address changes, the VPN tunnel will fail because the
FQDN does not resolve to your new address. If you have the option to
configure the update interval, set it to an appropriately short time.
Figure 5-5
To Next Page
Loading...
