NETGEAR Nighthawk M7 Pro - Connect a Computer to the Internet Using Ethernet

To connect a computer to the Internet using tethering:
1. If your mobile hotspot is powered on, press and hold the Power button for two
seconds, then select Shut down to power it off.
2. Connect your mobile hotspot to your computer using the included USB cable.
The mobile hotspot powers on and your computer detects the mobile hotspot.
Your computer connects to the Internet.
Connect a computer to the Internet
using Ethernet
You can connect a computer to your mobile hotspot using an Ethernet cable instead
of connecting with WiFi or tethering.
NOTE: When using battery power, the Ethernet port is disabled by default. You
must enable the Ethernet port from the home screen or use Plugged-In Mode
to connect using Ethernet.
To connect a computer to the Internet using Ethernet:
1. Quickly press and release the Power button to wake your mobile hotspot.
The lock screen displays.
2. Swipe up to unlock your mobile hotspot.
The home screen displays.
3. Using an Ethernet cable, connect your mobile hotspot to your computer.
Your computer detects the Ethernet connection.
NOTE: If your computer does not automatically switch to the Ethernet
connection, you might need to manually select the Ethernet connection from
your computer's network connection manager.
Your computer connects to the Internet.
User Manual23Connect devices to the Internet
Nighthawk M7 Pro