To configure port filtering from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Port Filtering.
The Port Filtering page displays.
2. Click or tap to select the Enable check box.
The Port Filtering list displays.
3. From the Port Filtering list, select one of the following:
•
Block List. Specific applications and services are not allowed to access the Internet
(block list).
•
Allow List. Only specific applications and services are allowed to access the
Internet (allow list).
Only one list at a time can be active, either a block list or an allow list.
4. Identify the ports to filter.
Enter a meaningful label that describes the application or service.
5. Enter the port being used.
6. Enter the communication protocol being used.
7. Click or tap Save.
Your settings are saved.
Change display settings from the
web user interface
You can change your mobile hotspot's display settings from the web user interface.
Lowering the LCD screen’s brightness level or reducing the screen time-out to a shorter
period reduces power consumption and might increase your mobile hotspot's battery
life.
To change display settings from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Device.
The Device page displays.
2. Adjust the following settings:
•
Screen Brightness: From the menu, select the screen brightness level.
•
Screen Timeout: From the menu, select a time period.
3. Click or tap Apply.
Your settings are saved.
User Manual74Access the web user interface
Nighthawk M7 Pro
To Next Page
Loading...
