NETGEAR Nighthawk M7 Pro - Select an APN to Use; Remove an APN Entry

•
None
•
IPV4
•
IPV6
•
IPV4V6
NOTE: PDP roaming protocol is the IP protocol used while you are roaming
(for example when you are traveling and the roaming network does not
support IPv6).
7. Select the network authentication mode:
•
None
•
PAP
•
CHAP
•
PAPCHAP
8. Enter the name and password, if they are required for the network.
9. Click or tap Add.
The entry is added to the table.
Select an APN to use
To select an APN to use:
1. From the web user interface dashboard, select Settings > Advanced > Cellular.
The Cellular page displays.
2. Select the Active radio button next to the APN entry.
The APN is selected.
Remove an APN entry
To remove an APN entry:
1. From the web user interface dashboard, select Settings > Advanced > Cellular.
The Cellular page displays.
2. Select the box to the left of the APN.
3. Click or tap Delete.
The APN is removed.
User Manual72Access the web user interface
Nighthawk M7 Pro